hotchoc setting up banana cakepop apikey

 

Open up banana cakepop and then proceed to sign in to your account. Create one if you don't have one. Choose your identity provider.

 





Click on Document or the page icon (just below the Cakepop icon) to open up a document. Then go slightly right, and create "New API Key" (as shown in the green arrow below). 


For the API type you can select API Service, I will select API Service. You can change to other API type later. 



Then configure your service, I will just enter "http://localhost:5098/" for schema endpoint and click "Apply".




In the Finish section click on Save.

Goto stages, and click on "Use default setup",

Next, goto the Overview tab and you should be able to get your API ID. 






Comments

Post a Comment

Popular posts from this blog

The specified initialization vector (IV) does not match the block size for this algorithm

Image
If you're getting  exception when trying to assigned key to a symmetric key and getting error message below :- The specified initialization vector (IV) does not match the block size for this algorithm And your code probably look like something below :- Then you need to go into debug mode and start looking into the supported size for IV as shown in diagram below :- As you can see, IV is 16 bytes, so you need to provide 16 bytes. The same goes for Key field too, if you're adding anything to it. As long as you provide a valid key size, then we're good and you're code will be ready.
Read more