Network Monitor MSI / Setup give Error Opening log file

When you try to install using Microsoft MSI, you bump into the following message

“Error Opening Installation log file. Verify that the specified log file location exists and is writable”

Workaround, extract the .exe file by using the following command below

NM33_x86.exe /c /t:c:\tools\networkmonitor

the /t switch is used to tell installer where to extract the file.

Then try to run netmon.msi to install network monitor. I tried it with Network Monitor 3.3 and it works (Netmon.msi and Microsoft_Parsers.msi)

Comments

Post a Comment

Popular posts from this blog

The specified initialization vector (IV) does not match the block size for this algorithm

Image
If you're getting  exception when trying to assigned key to a symmetric key and getting error message below :- The specified initialization vector (IV) does not match the block size for this algorithm And your code probably look like something below :- Then you need to go into debug mode and start looking into the supported size for IV as shown in diagram below :- As you can see, IV is 16 bytes, so you need to provide 16 bytes. The same goes for Key field too, if you're adding anything to it. As long as you provide a valid key size, then we're good and you're code will be ready.
Read more