trying to get bamboo running on window service to start ui process/task/thread

This is kinda dumb post.  :) Window service will not start your UI related task. That's by design.

And i went through the entire process of using CreateProcessAsUser and CreateProcessWithLogonW which attempts to run a process as a logged on user. CreateProcessWithLogonW is called after i stumble into the following

"If this function fails with ERROR_PRIVILEGE_NOT_HELD (1314), use CreateProcessWithLogonW ". 



End results for this :- the process gets created without any user interface, you can pretty much see it in the background. Wasted atleast 16 hours trying to work on this with same end results.



Comments

Post a Comment

Popular posts from this blog

The specified initialization vector (IV) does not match the block size for this algorithm

Image
If you're getting  exception when trying to assigned key to a symmetric key and getting error message below :- The specified initialization vector (IV) does not match the block size for this algorithm And your code probably look like something below :- Then you need to go into debug mode and start looking into the supported size for IV as shown in diagram below :- As you can see, IV is 16 bytes, so you need to provide 16 bytes. The same goes for Key field too, if you're adding anything to it. As long as you provide a valid key size, then we're good and you're code will be ready.
Read more