Empire Powershell Installation


Stumble upon a project called Empire Powershell. It is like a Metasploit that targets system running Powershell. I am not sure why i think it can run on Windows. So you guess it, I tried install it on Windows and it failed. Lots of question mark at this point.

A bit of Googling, finally I got it installed on my Linux box. Hurray!

It's pretty easy to setup. Just run install.sh on a folder called setup. After that, run Empire.

Now i can build my empire and kick start my evil plan to dominate the powershell world





Comments

Post a Comment

Popular posts from this blog

The specified initialization vector (IV) does not match the block size for this algorithm

Image
If you're getting  exception when trying to assigned key to a symmetric key and getting error message below :- The specified initialization vector (IV) does not match the block size for this algorithm And your code probably look like something below :- Then you need to go into debug mode and start looking into the supported size for IV as shown in diagram below :- As you can see, IV is 16 bytes, so you need to provide 16 bytes. The same goes for Key field too, if you're adding anything to it. As long as you provide a valid key size, then we're good and you're code will be ready.
Read more