Configuring serilog to support multiple file write using configuration file only.

 


You can use the following setup to configure our serilog to write to multipe file. If it is an error log event , it goes into a file called conditional.log If it is an information log event, it goes into a file called info.log


For more details of the configuration changes, please click here: https://gist.github.com/mitzen/81a9ffd24bc5294343c8ea62e77683a5


Comments

Post a Comment

Popular posts from this blog

The specified initialization vector (IV) does not match the block size for this algorithm

Image
If you're getting  exception when trying to assigned key to a symmetric key and getting error message below :- The specified initialization vector (IV) does not match the block size for this algorithm And your code probably look like something below :- Then you need to go into debug mode and start looking into the supported size for IV as shown in diagram below :- As you can see, IV is 16 bytes, so you need to provide 16 bytes. The same goes for Key field too, if you're adding anything to it. As long as you provide a valid key size, then we're good and you're code will be ready.
Read more