extending azure nat gateway with additional public ip

We can associate additional public IP to our NAT gateway by going into your Nat gateway -> Settings -> Outbound IP. Then click on 'Edit' - and then under Public IP, create public IP address. Provide an IP name and create it. I think for testing purposes this would be suffice but for production extensibility, it is best to use the "Public IP prefixes"

When i click "Ok" - i bump into this error. After a few retries, then i was able to get it working.



So this is what our NAT gateway would look like. 






Comments

Post a Comment

Popular posts from this blog

The specified initialization vector (IV) does not match the block size for this algorithm

Image
If you're getting  exception when trying to assigned key to a symmetric key and getting error message below :- The specified initialization vector (IV) does not match the block size for this algorithm And your code probably look like something below :- Then you need to go into debug mode and start looking into the supported size for IV as shown in diagram below :- As you can see, IV is 16 bytes, so you need to provide 16 bytes. The same goes for Key field too, if you're adding anything to it. As long as you provide a valid key size, then we're good and you're code will be ready.
Read more